CARLO GAVAZZI MDI 40 TF - CONFIGURATION SOFTWARE Manual de usuario descargar pdf (Pagina 17)

ENGLISH

password is not correct, the display shows “End” and the instrument

goes back to the measuring and control phase.

PROGRAMMING OF A NEW PASSWORD AND AUTOMATIC SELEC-

TION OF THE PROTECTION LEVEL OF THE CONFIGURATION DATA.

To enter the new Password:

•if the Password is “0”, press the “

” key when the display shows the

“PAS” message for the second time; enter the desired numerical code

using the “ ” or “ ” keys, then confirm it by pressing the “

”

key: the display will show the first configuration menu (“inP”);

•if the Password has already been entered, you can modify it following

the procedure described at No. 2); after the “PAS” message has been

shown a second time, enter the new numerical code using the “ ”

or “ ” keys and confirm it by pressing the “

” key: the display will

show the first configuration menu (“inP”).

Data protection levels:

•if the password is “0”, the configuration data are not protected by

undesired accesses;

•if the Password is a number between “1 and 127”, the configuration data

are almost entirely protected against undesired accesses;

•if the Password is a number between “128 and 255”, the configuration

data are protected against undesired accesses except for the program-

ming of the values (“SEt”) of set-point 1 and/or 2.

It is possible to reset the Password by entering the number 3584.

•

All programming/configuration steps of MDI40 are shown in the flow

chart on the top right of this page. The flow chart has been conceived

to make the operator better understand the programming structure

Gross Automation (877) 268-3700 · www.carlogavazzisales.com · [email protected]

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 26 27

Sin comentarios

CARLO GAVAZZI MDI 40 TF - CONFIGURATION SOFTWARE Manual de usuario Pagina 17