CARLO GAVAZZI MDI 40 TF - CONFIGURATION SOFTWARE Manual de usuario descargar pdf (Pagina 15)

ENGLISH

In the menus: exit from the programming phase (message “End“

on the display) and return to the measuring and control function; In the

secondary menus: exit and return to the main menu (the modification

of the selection or programming will not be saved if the

key has

not been previously pressed)

2. Display

Alphanumeric indication by means of a7-segment LED:

• of the measured value;

• of the programming parameters;

• of the measuring abnormal conditions.

3. LED

Indication of the alarm set-point status.

4. Engineering unit window

To insert the interchangeable engineering unit in the special

window, proceed as follows: remove the front cover by inserting a

suitable screw driver in the special lot on the short sides of the front

panel; force gently until the front cover is completely removed. Insert

the desired engineering unit by means of a pair of tweezers. Replace

the front cover by inserting it first in the lower part and then in the upper

part of the locking system.

Gross Automation (877) 268-3700 · www.carlogavazzisales.com · [email protected]

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 26 27

Sin comentarios

CARLO GAVAZZI MDI 40 TF - CONFIGURATION SOFTWARE Manual de usuario Pagina 15