CARLO GAVAZZI LDI 35 - CONFIGURATION SOFTWARE Manual de usuario descargar pdf (Pagina 15)

ENGLISH

the front cover by inserting it first in the lower part and then in the upper

part of the locking system.

OPERATING MODE

• Power-on

When you switch the unit on, the instrument shows for approximately 5

seconds the instruments’s software revision, for example: r.1.

• Displaying, control (if present) and diagnostics

The instrument shows continuously the value of the input variable as

defined in the programming phase.

The value shown on the display is continuously compared with the value

of the set-point and of the other parameters, thus generating the control

function by energizing/de-energizing the output relay.

• Programming

This phase is identified by the blinking of the decimal point on the right

side of the display.

To enter the programming phase, press the

key until “PAS” is

shown on the display; then “0” is displayed: the correct numerical code

(password) is to be entered. The following conditions may occur:

• 1) the operator hasn’t entered any Password: press the

key again

to enter the configuration menus of the instrument;

Gross Automation (877) 268-3700 · www.carlogavazzisales.com · [email protected]

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22 23

Sin comentarios

CARLO GAVAZZI LDI 35 - CONFIGURATION SOFTWARE Manual de usuario Pagina 15